Applies to
Netblazer / Power Blazer modules
Introduction
This procedure will help to configure the device for a smart loopback test.
Procedure to follow
Steps to use the Smart Loopback
1. Open the Mini Toolbox app:
2. Open the Netblazer/Power Blazer app:
3. Open the Smart Loopback app in the list of applications:
4. Once you are in the test configurator menu, the Modify Structure option allows the selection of the interface rate and select OK:
5. In the Test Configurator, you can change and verify the interface, the network, and the SFP+ info:
6. The next menu is the smart loopback menu. The Mode determines at which layer the Smart Loopback address/port swapping operation will be:
7. Start the test. Traffic data will be presented in the Results screen