Inserting a transceiver into the FTBx-88460


Applies to

FTBx-88460

Introduction

The following procedure explains how to insert or remove a transceiver system for the FTBx-88460 modules.

Procedure to follow

To insert a transceiver system into the FTBx-88460 module:

 1. Position the FTBx-88460 module so that its faceplate is facing you. When the FTBx-88460 module is already inserted into an FTB-4 Pro platform, position the FTB-4 Pro so that its display is facing down and the module is oriented as shown in the following picture.


 2. Remove the FILLER (protective cover) from the FTBx-88460.
     *Turn the two retaining screws counterclockwise until they are loose.

     *Hold the FILLER by the retaining screws and pull it out.

  DiagramDescription automatically generated


 3. Remove the transceiver system from its packaging:
     3a. Turn the two retaining screws counterclockwise until they are loose.

     3b. Hold the transceiver system by the handle (NOT by the connectors) and pull it out. Do not throw away the transceiver system packaging. It is recommended to insert the transceiver system into its packaging when removing it from the FTBx-88460 module.

       

 

 4. Insert the transceiver system into the FTBx-88460 module:

     4a.  Take the transceiver system and place it so that the handle is on the right side as shown.

     4b.  Insert the protruding edges of the transceiver system into the grooves of the receptacle’s module port.

 

   Diagram, engineering drawingDescription automatically generated

     4c. Push the transceiver system all the way to the back of the receptacle by pressing firmly only on the handle of the transceiver system until it is fully inserted.

 DiagramDescription automatically generated

Note: It is very important to push on the handle only to properly align the transceiver system within the FTBx-88460 module ensuring good electrical contact.

 

   4d. Turn the two retaining screws clockwise until they are tightened. This will secure the transceiver system into its “seated” position.

 

To remove a transceiver system from the FTBx-88460 module:

 1.  Position the FTBx-88460 module so that its faceplate is facing you.

 2. Turn the two retaining screws counterclockwise until they are loose.

 3. Hold the transceiver system by the handle (NOT by the connectors) and pull it out.

   

TextDescription automatically generated

 4. Cover the empty FTBx-88460’s receptacle with the supplied FILLER.

TextDescription automatically generated