Applies to
ConnectorMax2, FIP 400B series
Introduction
To use your EXFO FIP 400B series Fiber Inspection Probe with a Windows PC, ConnectorMax 2 must be installed on the computer.
Procedure to follow
1. Download ConnectorMax 2 to your PC.
- Download from this link: https://apps.exfo.com/en/exfo-apps/softwares/connectormax2/?application=CMAX2&platform=PC&seeall=1
2. Unzip the compressed file.
3. Open the extracted folder.
- If your operating system type is 32-bit, open the "32 Bit" folder.
- If your operating system type is 64-bit, open the "64 Bit" folder.
- If you are unsure, check by clicking WINDOWS START->SETTINGS ->SYSTEM -> ABOUT. The system type will be specified.
4. Run the Setup application.
5. Follow the on-screen prompts to complete the installation.
6. Launch ConnectorMax 2.